wiring diagram - tractor

Images
1-Wiring Diagram for 200, 210, 212 and 214 Tractors (Serial No.30,001-70,000)
2-Wiring Diagram for 208 Tractor
3-Wiring Diagram for 210, 212, 214 and 216 Tractors (Serial No.70,001-190,000)
4-Wiring Diagram for 210, 212, 214 and 216 Tractors (Serial No.190,000- )

Electric Lift Figure 2

Electric Lift Figure 3
The 200 Series Tractors all have a 12-volt electrical system. The electrical system consists of the cranking, ignition and charging systems, plus the accessory circuit.

The cranking system for 200, 210, 212 and 214 Tractors (Serial No. 30,001-70,000), consists of a battery, solenoid, circuit breaker, key switch, two neutral-start safety switches and a permanent magnet starter motor.

The cranking system for 208, 210, 212, 214 and 216 Tractors (Serial No. 70,001-), consists of a battery, solenoid, circuit breaker, key switch, three neutral-start safety switches and a permanent magnet starter motor.

200 Series Tractors (Serial No. 190,001 and up) are equipped with an electric PTO clutch. The clutch draws current from the battery and is activated by a switch on the dash.

All 200 Series Tractors are equipped with a battery-coil ignition system consisting of a battery, ignition switch, safety neutral-start and interlock switches, ignition coil, breaker points and condenser.

The battery is charged with a 15-amp alternator. A solid-state rectifier-regulator converts AC current from the alternator into DC current and also controls the rate of charging current to the battery.

Electric lift is available for 200 Series Tractors. The electric lift is position-responsive in that it reacts directly to control lever movement.

NOTE: On 208 Tractors the Yellow lead wire for extra equipment headlight is removed from the ignition switch accessory termianal and taped to the wiring harness.

 

 


 Home

News

Information

Troubleshooting

Service Guide

Links

Send Mail